Evaluation Board for ARM® with NXP LPC2919 This evaluation board hosts the LPC2919 microcontroller from NXP with an embedded ARM968E-S processor core and with an JTAG interface. In addition the driver chips for the external communication interfaces are included together with a wire-wrap area. All microcontroller IO port pins are accessible via connectors. The device drivers can be disabled via jumpers to have control of the microcontroller IO pins. The board is USB powered and enumerates as a mass storage memory device. Open the Readme.html on this mass storage device for more information. The features of the board are summarized below: Evaluation board for NXP LPC2919 microcontroller in LQFP144 package Support for internal 768kByte FLASH and 80kByte SRAM Support of 2 CAN ports Support of 2 RS232 ports External SRAM 512k x 16 2 x small 7-segment LEDs attached to port pins 3 buttons for reset, IRQ and port pin 32,768kHz + 16MHz Quartz Configuration of ports, reset, etc. via jumpers JTAG debugger support with JTAG connector 2 x 24 pin connector for BLDC motor add-on board 1.8V and 3.3V power regulator,+5V directly from USB Free wire-wrap area 20x20 pads USB powered or alternative external power via BLDC connector Power, reset and enumeration LED indicator PCB, size 100x110mm Hitex debugSTICK (included, but not shown): This compact JTAG debugger lets you debug your ARM-based microcontroller design and program the on-chip Flash memory.