The phyCORE module, combined with the PHYTEC Carrier Board, provides a platform to jump start embedded designs and propel concept to prototype and finished product.

Basic Rapid Development Kit (phyCORE-ARM9/LPC3180-BASIC)

• phyCORE-ARM9/LPC3180 Single Board Computer module
• phyCORE-ARM9/LPC3180 Carrier Board
• Serial cable, USB cable, AC adapter
• PHYTEC Spectrum CD including SBC hardware manual, evaluation compiler, software demos and Contoller User's Manual

IAR Rapid Development Kit (phyCORE-ARM9/LPC3180-IAR)

• Same as phyCORE-ARM9/LPC3180-BASIC, with:
• JLink USB-to-JTAG Interface (Segger-JLink)
• IAR EWARM (Embedded Workbench) KickStart CD (32K code limit)
• Bare PCB Expansion Board

Keil Rapid Development Kit (phyCORE-ARM9/LPC3180-KEIL)

• Same as phyCORE-ARM9/LPC3180-BASIC, with:
• Keil ULINK (Keil-ULINK) JTAG Debugger
• Keil RealView MDK-ARM Evaluation Software (16K code limit)
• Bare PCB Expansion Board

Linux Rapid Development Kit (phyCORE-ARM9/LPC3180-LINUX)

• Same as phyCORE-ARM9/LPC3180-BASIC, with:
• JLink USB-to-JTAG Interface (Segger-JLink)
• Bare PCB Expansion Board
• PHYTEC Tool CD with Linux LCP3180 BSP source code, bootloaders, ARM Linux GCC Compiler Toolchain, Flash programmer, Linux demo Image and filesystem.
• Optional Air101 Ethernet-USB adapter and powered USB hub (for load of Linux file system)

Carrier Board

The phyCORE-LPC3180 Carrier Board provides a flexible development platform enabling quick and easy start-up and subsequent programming of the phyCORE-LPC3180 Single Board Computer module. Available serial interfaces and USB signals from the module route to corresponding DB-9 and USB connectors. An MMC/SD card slot is also available for these expansion memory cards. The Carrier Board’s Expansion Bus allows easy connection of additional Add-On hardware featuring various functions that support fast and convenient prototyping and software evaluation.

Technical Features

• Carrier Board in EURO-card dimensions (100 x 160 mm)
• RS-232: 2x female DB-9 connectors support UART5 and UART2
• USB (Host/Device/OTG) connectors:
• Standard A type connector for USB host functionality
• Standard B type connector for USB device functionality
• miniAB type connector for OTG functionality
• 2.54mm pitch, 16-pin connector for JTAG debugging interface
• SD Card slot
• Reset push button
• Boot jumper
• 2x user buttons
• 4x user LEDs with jumpers to separate from I/O lines
• Battery receptacle for LPC3180 Real-Time Clock and SRAM back-up
• 2x8 2.54mm pitch connector for keyboard interface
• 1x potentiometer connected to one A/D input
• 5V. low-voltage socket for power supply connectivity
• 3V. and 5V. low voltage supplies for external devices and subassemblies
• GND connector (for connection of GND signal of measuring devices such as an oscilloscope)
• Expansion Bus: address, data, interface and all applicable I/O signals route from implemented phyCORE module to 2x80-pin Molex connectors, enabling connectivity to Add-On hardware