Hitex LPC2919 Evaluation Board + Hitex debugSTICK

Evaluation Board for ARM® with NXP LPC2919

This evaluation board hosts the LPC2919 microcontroller from NXP with an embedded ARM968E-S processor core and with an JTAG interface. In addition the driver chips for the external communication interfaces are included together with a wire-wrap area. All microcontroller IO port pins are accessible via connectors. The device drivers can be disabled via jumpers to have control of the microcontroller IO pins. The board is USB powered and enumerates as a mass storage memory device.

Open the Readme.html on this mass storage device for more information.

The features of the board are summarized below:

Evaluation board for NXP LPC2919 microcontroller in LQFP144 package
Support for internal 768kByte FLASH and 80kByte SRAM
Support of 2 CAN ports
Support of 2 RS232 ports
External SRAM 512k x 16
2 x small 7-segment LEDs attached to port pins
3 buttons for reset, IRQ and port pin
32,768kHz + 16MHz Quartz
Configuration of ports, reset, etc. via jumpers
JTAG debugger support with JTAG connector
2 x 24 pin connector for BLDC motor add-on board
1.8V and 3.3V power regulator,+5V directly from USB
Wire-wrap area 20x20 pads
USB powered or alternative external power via BLDC connector
Power, reset and enumeration LED indicator
PCB, size 100x110mm

Hitex debugSTICK (included, but not shown):
This compact JTAG debugger lets you debug your ARM-based microcontroller design and program the on-chip Flash memory.