phyCORE-ARM7/LPC2294 Rapid Development Kit

The phyCORE module, combined with the PHYTEC Carrier Board, provides a platform to jump start embedded designs and propel concept to prototype and finished product. The phyCORE System on Module is designed to be plugged into a PHYTEC Carrier Board. The PHYTEC Carrier Board contains the I/O connectors as well as any other interface circuitry not provided on the phyCORE module itself.

Basic Rapid Development Kit

• phyCORE-ARM7/LPC229x System on Module (SoM)
• phyCORE Carrier Board HD200
• Ethernet adapter
• JTAG cable
• serial cable, AC adapter
• PHYTEC Kit CD including SoM hardware manual, evaluation compiler, software demos and controller User's Manual
• Access to schematics with product registration
• Bare PCB Expansion Board
  

IAR Rapid Development Kit

IAR bundles RTOS, TCP/IP Protocol Stack, USB Device Stack, Flash File System and CAN Stack for NXP Semiconductors (founded by Philips) ARM7 and ARM9. Further information available upon your request to info@iar.com

• same as phyCORE-ARM7/LPC2294-BASIC, with:
• IAR j-link USB-to-JTAG Interface
• IAR 32K-limited EWARM KickStart CD

Keil Rapid Development Kit

• same as phyCORE-ARM7/LPC2294-BASIC, with:
• Keil ULINK2
• Keil 32K-limited RVMDK-ARM Evaluation Software

Carrier Board

Each phyCORE module supported by the phyCORE Carrier Board HD200 has a section in its manual dedicated to the use of the module in question with the phyCORE Carrier Board HD200.

The phyCORE Carrier Board HD200 provides a flexible development platform enabling quick and easy start-up and subsequent programming of the PHYTEC SoMs with 200-pin high density Molex connectors. Depending on the controller features of the implemented SoM, simple jumper configuration routes the available serial interfaces (RS-232, RS-485, CAN) to corresponding DB-9 connectors. The Carrier Board also offers a CAN transceiver is available that can be supplied with a separate voltage for galvanic isolation by a special CAN connector. The Carrier Board design allows easy connection of additional expansion boards featuring various functions that support fast and convenient prototyping and software evaluation.

Technical Features

• Carrier Board in EURO-card dimensions (100 x 160 mm)
• Receptacle socket for speedy and secure insertion, and subsequent programming, of the PHYTEC System on Module with 200-pin high-density (0.635 pitch) Molex connectors.
• Dual DB-9 sockets for serial RS-232 interface connectivity
• Dual DB-9 connectors for CAN or RS-485 interface connectivity
• Space for an optional DS2410 Silicon Serial Number chip (for networking identification purposes)
• Receptacle for an optional battery
• Low-voltage socket for power supply connectivity  
• Voltage supply for external devices and subassemblies
• GND connector (for connection of GND signal of measuring devices such as an oscilloscope)
• Expansion Bus: address, data, interface and all applicable I/O signals route from implemented phyCORE module to 2x80-pin Molex connectors, enabling connectivity to Add-On hardware

ETM (Embedded Trace Module) connectivity